Ayre K-5xe Bedienungsanleitung PDF herunterladen (Seite 10)

Input Source Selection

The input selector buttons are located below the

display. Alpha-numeric labels that match the

connector labels on the rear panel (B1, B2, S1, S2)

are used to denote the inputs. When the unit is first

connected to an AC power source, the “B1” input is

selected by default.

Tape Output

The “Tape Output” function

does not operate on the “S2”

input. This avoids the

undesired possibility of

creating a feedback loop.

When the “Tape Output” button is pressed, the

indicator will light up and the signal from the

currently selected source component will be routed

to the “Tape Out” connectors. This allows a

recording to be made.

Turn the “Tape Output” off, unless a recording is

being made. This will completely disconnect the

recorder from the K-5xe

(including the ground

connection), avoiding the possibility of undesired

ground loops.

Additional Functions

The following function is available only via the

remote control handset.

Display

The display of the K-5xe

may be turned off if

desired. A single blue light indicates that the

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Ayre K-5xe Bedienungsanleitung Seite 10