Ayre K-5xe Bedienungsanleitung PDF herunterladen (Seite 6)

with no moving parts. Please be aware that they can

be overloaded if the output voltage from the source

component is too high.

Do not use a source component that has

an output level greater than4Vrms

unbalanced, or 8 V rms balanced.

Using a source component with too great an output

level will cause distortion.

The input connectors on the

rear panel are labeled to

match the input selector

buttons.

In this modern era of diverse source components, it

has become impractical to pre-label the inputs with

the actual name of the source. Instead, the K-5xe

has simple alpha-numeric labels that allow you to

easily remember the selector button associated with

each source component.

Tape Outputs

By connecting the “Tape Out” jacks on the rear of

the K-5xe

to a recorder with analog inputs,

recordings may be made directly from the other

source components connected to your preamplifier.

The tape outputs are switched on and off at the front

panel or via the remote. Please refer to the section

“Controls and Operation” for further information.

If a recorder is not installed in

your system, the “S2” input

performs exactly like the other

unbalanced inputs.

If you are connecting a recorder to your

system, be sure to connect its outputs to

the “S2” input of the K-5xe

This will prevent the undesired possibility of

creating a feedback loop when making a recording.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Keine Kommentare

Ayre K-5xe Bedienungsanleitung Seite 6